HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual page 116

5. Insert the slot load assembly into the chassis optical cage until it reaches the release latch.
Pull the latch
Release the latch and then slide the assembly further into the chassis until it snaps into place
as shown in the following figure.
NOTE:
Figure 5-36
6. Connect the chassis power cable to the optical disk drive power cable as shown in the following
figure.
Figure 5-37
104 Chapter 5 Replacing components
and slide the slot load assembly into the chassis, past the latch.
Install the slot load optical bay with the slot load drive at the top.
Installing the slot load assembly
Connecting chassis power cable to optical disk drive power cable
2
ENWW