Removing a hard disk drive from the optical drive bay
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
3.
Remove the airflow guide (see
4.
Remove the expansion card support (see
5.
Disconnect the power and data cables from the rear of the hard drive as shown in the following
figure.
Figure 5-59
6.
Lift the drive release latch at the green touch point
chassis as shown in the following figure
Figure 5-60
120 Chapter 5 Replacing components
Removing the airflow guide on page
Removing the power and data cables
Removing the drive from the ODD bay
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
, and then slide the hard drive carrier from the
.
2
74).
76).
77).
78).
ENWW