Specifications; Loading Originals - Kyocera TASKalfa 620 Operation Manual

Preparing to Copy

Loading Originals

Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals individually. Both
sides of two-sided originals are scanned automatically.
The document processor supports the following types of originals.
Items
Weight
Size
Capacity
Precautions on Types of Originals for the Document Processor
Do not use the document processor for the following types of originals. In addition, if originals have
punched holes or perforations, load them with the holes or perforations away from the leading edge.
•
•
•
•
•
•
•
How to Load Originals
Follow these steps to load originals in the document processor.
IMPORTANT: Before loading originals, be sure there
are no originals left on the original eject table. Originals
left on the original eject table may cause the new
originals to jam.
2-16

Specifications

45 g/m² to 160 g/m²
Minimum: 5
Standard paper (80 g/m²), colored paper or recycled paper: 200 sheets
(30 sheets in Mixed Size Originals mode)
Coated paper: 1 sheet
High quality paper, 50 g/m²: 200 sheets
High quality paper, 110 g/m²: 145 sheets
Transparencies for overhead projectors
Delicate originals such as carbon paper, crumpled paper, or vinyl sheets
Irregularly shaped (non-rectangular) originals, wet originals, or originals containing adhesive
tape or glue
Originals bound with clips or staples. (To avoid jams, remove the clips or staples and straighten
any curls, wrinkles, or creases before loading them. Failure to do so may cause the originals to
jam.)
Originals with cut-out sections or with very slippery surfaces
Originals with correction fluid which is not dried
Originals with folds. (To avoid jams, straighten the folds before loading them. Failure to do so
may cause the originals to jam.)
× 8 " (A5R); Maximum: 11 × 17" (A3)
1/2 1/2