Original Placement Indicator - Kyocera TASKalfa 620 Operation Manual

1
Adjust the original width guides to fit the originals.
2 Place the originals. Put the side to be copied (or the
first side of two-sided originals) face-up. Slide the
leading edge into the document processor as far as it
will go.
IMPORTANT: Confirm that the original width guides
exactly fit the originals. If there is a gap, readjust the
original width guides. The gap may cause the originals
to jam.
Pull out the ejection guide for originals of 8
(B4) or 11 × 17" (A3).
Ensure that loaded originals do not exceed the level
indicated. Exceeding the maximum level may cause
the originals to jam.

Original placement indicator

The original placement indicator is lit or unlit
depending on how originals are
placed. Indications and their status are as
P
follows.
• Green (left indicator) lit : Original is placed
properly.
• Green (left indicator) blinking : Original is not
placed properly. Remove and place again.
• Red (right indicator) blinking : Original is
jammed. Remove the jammed original and
place it properly.
× 14"
1/2
Preparing to Copy
2-17