4.6.22 VERIFY command
Bit
7
Byte
0
1
Logical Unit Number
2-5
6
7-8
9-11
The VERIFY command verifies for the specified number of blocks from the
specified logical block address.
Logical Block Address specifies the head logical block address from which
verification starts.
Verification Length specifies the number of blocks to be verified and transferred.
When Verification Length is 0, the command verifies no block and ends normally.
The ByteChk bit indicates data compare execution. However, since the ByteChk
is not supported, it must be set to 0. If a value 1 is specified, the command ends
with Check Condition.
4.6.23 WRITE (10) command
Bit
7
Byte
0
1
Logical Unit Number
2-5
6
7-8
9-11
C156-E227-01EN
Table 4.111 VERIFY command
6
5
4
Operation Code (2Fh)
Logical Block Address
Reserved
Verification Length
Reserved
Table 4.112 WRITE (10) command
6
5
4
Operation Code (2Ah)
Logical Block Address
Reserved
Transfer Length
Reserved
4.6 Packet Commands
3
2
ByteChk
Reserved
3
2
Reserved
1
0
Reserved
1
0
4-79