Table 4.93 Defect List Format; Table 4.94 Defect List Header; Table 4.95 Defect Descriptor - Fujitsu MCM3064AP Product Manual

When Plist is 1, the command transfers header and PDL. When Glist is 1, this
command transfers header and SDL. When both Plist and Glist are 0, it transfers
the header. When both Plist and Glist are 1, the command transfers PDL and
SDL. PDL and SDL are arranged in an ascending order.
Table 4.93 lists the supported defect list format. If any other format is specified,
the command assumes that the format listed in Table 4.93 is specified, and reports
Recovered Error.
Defect List
Format
Table 4.94 summarizes the defect list header. Table 4.95 lists the defect
descriptors.
Bit 7
Byte
0
1 0
2-3
4-n
Byte
0-2
3
4-7
C156-E227-01EN

Table 4.93 Defect List Format

101 Physical sector address format

Table 4.94 Defect List Header

6 5
0 0
Defect List length
Defect Descriptor(s)

Table 4.95 Defect Descriptor

Defect block track address
00h
Defect block sector address
Data format
4 3
00h
Plist Glist
Defect Descriptor
4.6 Packet Commands
2 1 0
Defect List Format
4-69