Table 4.101 Sense Key Code; Table 4.102 Logical Block Address Format - Fujitsu MCM3064AP Product Manual

Sense Key outlines the error. The definition of Sense Key is listed in Table 4.101.
Sense Key Abbreviation
0h NO SENSE
1h RECOVERED ERROR
2h NOT READY
3h MEDIUM ERROR
4h HARDWARE ERROR
5h ILLEGAL REQUEST
6h UNIT ATTENTION
7h DATA PROTECT
8h BLANK CHECK
9h-Ah Reserved
Bh ABORTED
COMMAND
Ch-Fh Reserved
The information indicates LBA of an error block. If an error occurs in multiple
blocks, the LBA of the first block is indicated.
Command-Specific Information indicates the logical track address of the block
indicated in Information (or logical block address). The track address format is
shown in Table 4.102.
C156-E227-01EN

Table 4.101 Sense Key code

Indicates there is no sense key to be reported. NO
SENSE is set when a command ends normally.
Indicates that recovery ends successfully or that the
command ends normally using the internal default value
even if invalid data is detected in command parameters.
(Not reported when the PER bit is 0.)
Indicates that access with an access command cannot be
executed.
Indicates that an unrecoverable error is detected due to
media failure.
Indicates that an unrecoverable error is detected due to
hardware failure.
Indicates that command packets or command parameters
contains invalid data. Media data remains unchanged.
Indicates that reset, power-on, or media exchange is caused.
Indicates that media is write-protected with the Write
Protect key or the device is softwre-write-protected.
Indicates that a blank sector is detected. Not used
Not used
Indicates that the command is interrupted.
Not used

Table 4.102 Logical block address format

Byte
8-9 Logical track address
10 00h
11 Logical sector address
Definition
Description
4.6 Packet Commands
4-73