Weekly Checks And Service; Monthly Checks And Service - Frymaster Protector Series Installation & Operation Manual

Protector series gas fryers footprint pro series

Hide thumbs Also See for Protector Series:

Table of Contents

There are no periodic preventive maintenance checks and services required for your FootPrint Pro

Filtration System other than daily cleaning of the filter pan with a solution of hot water and

detergent.

If you notice that the system is pumping slowly or not at all, verify that the filter pan screen is on the

bottom of the filter pan, with the paper on top of the screen. (If the unit is equipped with a Magnasol

filter screen rather than with the standard screen and paper system, verify that the O-ring on the

bottom fitting of the screen in present and in good condition.) Verify that the two O-ring(s) on the

fitting at the right front of the filter pan are present and in good condition.

6.3

WEEKLY CHECKS AND SERVICE

6.3.1 Drain and Clean Frypot

Never operate the appliance with an empty frypot. The frypot must be filled with

water or oil before lighting the burners. Failure to do so will damage the frypot and

may cause a fire.

6.3.2 Boiling Out the Frypot

After the fryer has been in use for a period of time, a hard film of caramelized oil will form on the

inside of the frypot. This deposit must be periodically removed to maintain your fryer's efficiency.

See section 4.11 page 4-16 for instructions on boiling out the frypot.

6.4

6.4.1 Check Computer Magic 7 Set Point Accuracy

(This check applies only to units equipped with Computer Magic 7 Controllers.)

1. Insert a good-grade thermometer or pyrometer probe into the oil, with the end touching the fryer

temperature-sensing probe.

2. When the computer display shows a series of four dashes "----" with no dot between the first and

second dashes (indicating that the frypot contents are within the cooking range), press the

switch once to display the temperature of the cooking oil as sensed by the temperature probe.

3. Press the

switch twice to display the set point.

4. Note the temperature on the thermometer or pyrometer. All three readings should be within

± 5ºF (2ºC) of each other. If not, contact a Factory Authorized Service Center for assistance.

DANGER

6-2

Table of Contents

Protector