Table of Contents
Advertisement
5. When the hold-down ring is in position,
if using filter paper, sprinkle one packet
of filter powder evenly over the paper.
(See Figure 4)
If using a filter pad, position the hold
down ring on top of the pad. DO NOT
use filter powder with the pad.
6. Replace the crumb tray in the filter pan, then push the filter pan back into the fryer, positioning it
under the drain.
5.2.2
Preparation for Use with the Magnasol Filter Assembly
1. Pull the filter pan out from the cabinet
and
remove
the
Magnasol filter assembly (See Figure 5).
Clean as directed in section 5.4.
The pan cover must not be removed
except for cleaning, interior access, or to
allow a shortening disposal unit (SDU)
to be positioned under the drain.
NOTE:
Refer to Section 5.4 for
instructions on how to disassemble and
reassemble the Magnasol filter screen
assembly.
2. Inspect the fitting on the bottom of the
Magnasol filter assembly to ensure that
the O-ring is present and in good
condition. (See Figure 6)
3. Inspect the filter pan connection fitting
to ensure that both O-rings are present
and in good condition. (See Figure 7)
crumb
tray
and
Figure 5
Inspect the filter
screen O-ring.
Inspect the filter
connection fitting
O-rings.
5-4
Figure 4
Figure 6
Figure 7
Advertisement
Table of Contents
