Table of Contents
Advertisement
4.7
CM7 Button Description and Functions
4.7.1 Navigation Buttons
The menu on the CM7 uses
navigate the various menus and submenus (see Figure 1).
When programming, the left screen shows a menu or submenu item. The right screen is for data
entry. Data is entered with alpha-numeric characters, scrolling through lists or by toggling between
choices.
During programming, if a button is not pushed within one minute, the computer returns to operation
mode.
4.7.2 Temperature and Unlock Buttons
TEMP
The
button (see Figure 1), if pressed once while the fryer is on, displays current vat
temperature on both sides. If the
of the vats. If the fryer is off, the display shows the current versions of software. The
button (see Figure 1), if pressed once while the fryer is on, shows the recovery time for each vat
from the last test. Recovery displays the time required for the fryer to raise the temperature of the oil
50°F (28°C) between 250°F (121°C) and 300°F (149°C). Maximum recovery time should not
exceed 1:40 for electric or 2:25 for gas. If the fryer is off, pressing the unlock button once allows
access to Program Mode; pressing twice allows access to Manager Mode and pressing three times
allows access to Tech Mode.
4.7.3 Cook Cycle and Selection Buttons
The
and
buttons are dual-function buttons shared
1
with the number
and
below the LED displays (see Figure 2). Use these buttons
to select or cancel functions. The
out of submenus.
4.7.4 Melt Cycle and Cooking Displays
Once the computer is switched on, it displays CYCL during melt cycle until the oil reaches 180°F
(82°C). The display changes to LOW TEMP until setpoint is reached. Once setpoint is reached,
the computer will display dashed lines or the product name
34
tu
and
TEMP
button is pressed twice, it shows the setpoint temperatures
2
buttons. They are located directly
button is used to back
buttons to
4-7
Figure 1
UNLOCK
Figure 2
Advertisement
Table of Contents
