Installation Instructions - Frymaster FLYMASTER KSCFH18E Installation & Operation Manual

KSCFH18E COOL ZONE SERIES ELECTRIC FRYERS
CHAPTER 3: INSTALLATION INSTRUCTIONS
3.1 Installing the Fryer
A. Initial Installation: If installed with legs, do not push against any unit edges to adjust its position.
Use a pallet or lift jack to lift it slightly and place it where it is to be installed.
B. Relocating the Fryer: If relocating a fryer installed with legs, remove all weight from each leg
before moving.
Note: If a leg becomes damaged during movement, contact a factory authorized service agent for
immediate repair/replacement of the damaged leg.
This fryer may tip and cause personal injury if not secured correctly in a stationary
position. Drain all oil/shortening from fryer before moving. Hot oil will splash and
3.2 Leg and Caster Installation
A. General
1. Install legs (front) and rigid casters (rear) near where the fryer is to be used, as neither are
secure for long transit. The KSCFH18E electric fryer cannot be curb mounted and must be
equipped with the legs and rigid casters provided.
2. When positioning the fryer, gently lower the fryer into position to prevent undue strain on
the legs and internal mounting hardware. Use a pallet or lift jack to lift and position the
fryer if possible. Tilting the fryer may damage the legs.
3. The rigid casters must be installed on the fryer rear only.
4. Proceed to Step 3.3, Leveling the Fryer, after legs and rear rigid casters are installed to
ensure the fryer is level before using.
B. Leg and Rigid Caster Installation
1. Remove unit from pallet.
2. Carefully raise unit with forklift, pallet jack, or other steady means.
3. Place one lock washer on each hex head screw.
DANGER
cause severe burns upon contact.
3-1