Fuji Xerox DocuPrint M355 df User Manual page 55

11
Insert the standard 250 sheet tray into the printer, and push until it stops.
IMPORTANT:
• Do not use excessive force on the tray. Doing so could damage the tray or the inside of the printer.
12
Insert the bypass tray into the printer, push until it stops, and close the cover.
13
Reconnect all cables into the rear of the printer and turn on the printer.
NOTE:
• The printer will automatically detect the attached tray but will not detect the paper type.
14
Print the System Settings page to confirm the optional 250 sheet feeder is installed correctly.
Press the (System) button.
a
Select Report / List, and then press the
b
Select System Settings, and then press the
c
The System Settings page is printed.
15
Confirm Tray 2 (250 Sheet Feeder) is listed under Printer Options in the System Settings page.
If the feeder is not listed, turn off the printer, unplug the power cord, and re-install the optional 250 sheet feeder.
16
After loading paper in the optional 250 sheet feeder, specify the paper type from the printer operator panel.
Press the (System) button.
a
Select Tray Settings, and then press the
b
Select Tray 2, and then press the
c
Select Paper Type, and then press the
d
Select the paper type for the optional 250 sheet feeder, and then press the
e
17
If you installed the optional 250 sheet feeder after installing the print driver, update your driver by following the
instructions for each operating system. If the printer is on a network, update the driver for each client.
button.
button.
button.
button.
button.
button.
55
Basic Operation