Table of Contents
Advertisement
Do not obstruct the ventilation openings.
The machine has ventilation opening. Poor
ventilation may cause overheat inside the
machine and can lead a fire.
Always locate the equipment in an area
that has adequate ventilation, and space
for servicing. See installation instructions
for minimum dimensions. Keep the
ventilation and service space clear to allow
an access to the power plug. You would be
required to unplug the machine when an
abnormal condition is encountered.
Do not incline the product more than 10
degrees.
In order to use and maintain this product in
a good performance and condition, make
sure to use the product within the following
environment:
• Temperature: 10~32°C
• Humidity: 35~85%
When the product is left in a freezing cold
room and the room is rapidly warmed up by
heater, it can generate water drops inside
the machine and cause a partial deletion on
printing.
Operational Safety
Any operator product maintenance
procedures will be described in the
customer documentation supplied with the
product. Do not carry out any maintenance
procedures on this product which are not
described in the customer documentation.
This equipment has been designed to
restrict operator access to safe areas only.
Operator access to hazardous areas is
restricted with covers or guards, which
would require a tool to remove. Never
Unit:mm
remove these covers or guards.
If any of the following conditions occur,
switch off the power to the machine
immediately and disconnect the power
cord from the electrical outlet. Call an
authorized local service representative to
correct the problem.
Others
Safety Notes
Eng
Eng
11
Advertisement
Table of Contents
