Table of Contents
Advertisement
6.
If an internal hard disk is installed, remove it
temporarily.
Use a screwdriver to remove the two screws
from the outside of the printer. Hold the
internal hard disk by the part shown in the
figure and pull it out upward.
7.
Align the notch on the font ROM with the
projection on the ROM slot and insert the
ROM at an angle into the slot.
Important
• The font ROM should be installed at the right of the
controller board. The slot at the left of the controller
board is for a memory card (optional). Make sure to
insert the font ROM into the correct slot.
8.
Push the font ROM as shown in the figure.
When the ROM is inserted correctly, it clicks
into place.
Note
• To remove the font ROM, push the retaining clips on
both ends in the outward directions and pull the ROM
out of the slot.
9.
If you removed an internal hard disk in a
previous step, re-install it into the controller
board.
10. Re-attach the metal plate cover on the
printer by tightening the three screws
loosened in Step 4.
11. Re-attach the rear cover on the printer by
tightening the two screws removed in Step 2.
12. Plug in the power cord and switch the power
on by pressing the power switch to the <|>
position.
The installation is now complete.
Note
• You can check whether the KR font kit has been
installed correctly by printing out the [PCL Font List]. For
information on how to print the [PCL Font List], refer to
"Printing a Report/List" (P. 31).
Installing the KR Font Kit
IE
IE
81
Advertisement
Table of Contents
