Xerox DocuPrint 3055 Quick Reference Manual page 12

- The equipment emits smoke or a
surface of the equipment becomes
unusually hot.
- The equipment emits unusual noises or
odors.
- The power cord is damaged or frayed.
- A wall panel circuit breaker, fuse, or
other safety device has been tripped.
- Liquid has spilled into the equipment.
- The equipment is exposed to water.
- Any part of the equipment is damaged.
Never push objects of any kind into slots or
openings on the equipment. Do not place
any of the followings on the machine;
- Liquid container such as a vase or
coffee cup
- Metal parts such as staples or clips
- Heavy object
When those are spilled over, slipped into or
fall from the machine, it can cause electric
shock, fire or injury.
Do not use conductive paper, e.g. carbonic
paper or coated paper. When paper jam
occurs, they can cause a short-circuit and
fire.
Always use materials specified for this
product. The use of other materials may
result in poor performance and may create
a hazardous situation. Do not use aerosol
cleaners, they may be explosive and
flammable under certain circumstances.
Laser Safety
CAUTION: Use of controls, adjustments or
performance of procedures other than
those specified herein may result in
hazardous light exposure.
With specific regard to laser safety, the
equipment complies with performance
standards for laser products set by
government, national and international
agencies as a Class 1 laser product. It does
not emit hazardous light, as the beam is
totally enclosed during all phases of
customer operation and maintenance.
12
Safety Notes
Always follow all warnings and instructions
that are marked on or supplied with the
equipment.
Do not override or disable electrical or
mechanical interlocks. Do not place a
magnet near the safety switch of the
machine. A magnet can activate the
machine accidentally, resulting in injuries.
The machine has a circuit breaker. In the
event of a current leakage, the breaker will
automatically cut off the power circuit to
prevent any leakages or fire.
The breaker is normally On ("|").
Once a month, check the breaker for
correct operation by using the following
procedure.
1. Press the Test button. The breaker
switch is turned Off. ("O") (This means
that the breaker is OK.)
2. Return the breaker switch to On ("|").
If you notice any unusual condition, contact
your local Fuji Xerox representative.
TEST button
RESET button
When removing jammed paper, do not try
to remove paper or paper piece deep inside
the machine. Also, do not try to remove
paper wrapped around the heat roller. It
can cause injury or burn.
Switch off the machine immediately and
contact your local Fuji Xerox
representative.