Table of Contents
Advertisement
6.
If a network expansion card is installed,
remove it temporarily.
7.
If another memory card is already installed,
push the retaining clips on both sides in the
outward direction. After the memory card
pops up, pull it out at an angle.
8.
Hold the new memory card so that the notch
on the card comes above the center of the
card.
notch
9.
Align the notch on the new memory card with
the projection on the RAM slot (printed as
"SDRAM op." on the controller board), and
insert the memory card at an angle into the
slot.
Important
• The memory card should be installed to the left of the
controller board. The slot at the right part of the
controller board is for an optional ROM, which is
installed parallel to the controller board. Make sure to
insert the memory card into the correct slot.
10. Push the new memory card as shown in the
drawing. When the card is installed correctly,
it clicks into place.
11. If the network expansion card was removed,
re-install it to the printer.
12. Re-attach the metal plate cover on the
printer by tightening the three screws
loosened in Step 4.
13. Re-attach the rear cover on the printer by
tightening the two screws removed in Step 2.
14. Plug in the power cord and switch on the
power by pressing the power switch to the
<|> position.
The installation is now complete.
Installing Additional Memory
IE
IE
73
Advertisement
Table of Contents
