Timing Adjust - Barco LED-PRO User Manual

qáãáåÖ=^Çàìëí
From the LED Output Menu, select Timing Adjust to display the Output Timing Adjust
Menu, which enables you to make adjustments to the currently selected output format's
timing parameters. A sample menu is shown below.
T I M I N G A D J U S T
> H Total
Figure 4-64. Output Timing Adjust Menu (sample)
Following are descriptions of each menu function:
•
•
•
•
•
•
•
•
oÉÑêÉëÜ=o~íÉ
From the LED Output Menu, scroll to the Refresh Rate function and press SEL to adjust
the output's refresh rate. If the LED tile type is known, this function also sets the refresh
rate for the wall.
•
LED-PRO • User's Guide
H Positio n
H Size
H Sync
V Total
V Position
V Size
V Sync
H Total — adjusts (in pixels) the total pixel count per line — for the selected
output.
H Position — adjusts (in pixels) the offset of the start of active area from H sync.
H Size — adjusts (in pixels) the size of the active area.
H Sync — adjusts (in pixels) the H sync width.
V Total — adjusts (in lines) the total line count per frame.
V Position — adjusts (in lines) the offset of the start of active area from V sync.
V Size — adjusts (in lines) the size of the active area.
V Sync — adjusts (in lines) the V sync width.
Note When the output format is NTSC or PAL, H Total and V Total
cannot be changed.
Values are 60 Hz or 50 Hz.
Important The 60 Hz setting is actually 59.94 Hz. This setting is
intended for use with NTSC and PC inputs.
4. Operation
Using the Expert Mode Menu
840
38
800
10
636
28
600
10
81