Diagnostics Port; Rs-232 Port - Barco LED-PRO User Manual

_K==oÉãçíÉ=`çåíêçä=mêçíçÅçä
Default Serial Parameters
aÉÑ~ìäí=pÉêá~ä=m~ê~ãÉíÉêë
Default serial communications parameters are provided for the following two ports:
•
•
Please note:
•
•
aá~ÖåçëíáÅë=mçêí
Following are the default serial communications settings for the Diagnostics port, which is
used for diagnostics, software upgrades and serial commands (e.g., via HyperTerminal).
•
•
•
•
•
•
opJOPO=mçêí
Following are the default serial communications settings for the RS-232 port, which is used
to communicate with the Director Toolset.
•
•
•
•
•
•
126

Diagnostics Port

RS-232 Port

The system returns to these values after a factory reset.
These settings can be changed using the menu system.
~
In Chapter 4, refer to the
instructions on changing Diagnostic Port settings.
~
In Chapter 4, refer to the "RS232" section on page 51 for instructions on
changing the RS-232 port settings.
Baud Rate = 38.4K baud
Parity = NONE
Stop Bit = 1
Data Bit = 8
Echo = ON
Flow Control = NONE
Baud Rate = 19.2K baud
Parity = NONE
Stop Bit = 1
Data Bit = 8
Echo = ON
Flow Control = NONE
"Diagnostic RS232" section on page 88 for
LED-PRO • User's Guide