Sharpness; Clip To Subblk; Luma Tracking - Barco LED-PRO User Manual

p~íìê~íáçå
From the SDI Source Alignment Menu, select Saturation to adjust the saturation of the
selected input.
•
•
pÜ~êéåÉëë
From the SDI Source Alignment Menu, select Sharpness to adjust the sharpness of the
selected input. This selection sets the scaler's sharpening (or softening) value.
•
•
`äáé=íç=pìÄ_äâ
From the SDI Source Alignment Menu, select Clip to SubBlk to eliminate low level noise
in black regions of the image.
•
•
iìã~=qê~ÅâáåÖ
From the SDI Source Alignment Menu, select Luma Tracking to prevent green haze
from appearing in regions of low light.
•
•
bafa=asf
From the SDI Source Alignment Menu, select EDID DVI to display the EDID DVI In
Format Menu, which enables you to update LED-PRO's preferred EDID resolution. Refer
to the "Programming
LED-PRO • User's Guide
The adjustment range is -75 to +125.
100 is the default setting.
The sharpening range extends from -10 (softest) to +10 (sharpest).
0 is the default setting (which sets the scaler to its optimum sharpness).
The adjustment range is 0 to -15.
0 is the default setting.
The adjustment range is 0 to -15.
0 is the default setting.
EDID" section on page 53 for instructions.
4. Operation
Using the Setup Menu
47