Rs232; Reset Config - Barco LED-PRO User Manual

4. Operation
Using the LED Menu
opOPO
From the LED Menu, select RS232 to display the RS232 Menu, which enables you to set
the RS-232 baud rate for the Serial port — not the Diagnostic port. The Serial port is
used for communications with the Director Toolset.
R S 2 3 2
> Bau d
Figure 4-86. RS232 Menu (sample)
•
p~îÉ=`çåÑáÖ
On the LED Menu, select Save Config to save all current output configuration settings in
non-volatile memory.
oÉëÉí=`çåÑáÖ
On the LED Menu, select Reset Config to remove all user-entered configuration settings,
and restore the default values for the current output format.
104
Select the Baud field to set the Serial port's baud rate.
Note This function is identical to the Save Config function located
in the Output Setup Menu (SETUP > Expert Mode >
Output). Refer to the
instructions.
Note This function is identical to the Reset Config function located
in the Output Setup Menu (SETUP > Expert Mode >
Output). Refer to the
instructions.
1920 0
"Save Config" section on page 84 for
"Reset Config" section on page 84 for
LED-PRO • User's Guide