Table of Contents
Advertisement
`çååÉÅíáîáíó=aá~Öê~ã
The figure below provides a sample connectivity diagram:
Up to 4 Inputs
Camera (Composite)
DVR (SDI)
PC (RGB)
PC (DVI)
Figure 1-1. LED-PRO System Diagram (sample)
Please note the following points regarding the diagram:
•
•
LED-PRO • User's Guide
(Optional)
Fiberlink Transmitter
LED-PRO
Laptop PC (Director Toolset)
The maximum of four inputs are shown, one each in RGB, DVI, Composite and
HD-SDI formats.
Two different paths from LED-PRO to the LED wall are shown:
~
Via DVI, direct between the LED-PRO and the wall.
~
Via DVI and fiber optics, via the optional Barco Fiberlink Transmitter and
Receiver.
~
An optional Barco AEC (Ambient Environment Controller) is shown.
~
The (customer supplied) laptop PC is required for LED wall calibration,
via Director Toolset.
Note
Contact your Barco sales representative for information on
Fiberlink and AEC systems. These products are not
discussed in this user's guide.
Fiberlink Receiver
Fiber Optics
DVI (Direct)
Ethernet or
RS-232
NK==fåíêçÇìÅíáçå
Connectivity Diagram
(Optional)
LED Wall
(Optional) AEC
7
Advertisement
Table of Contents
