Table of Contents
Advertisement
s=mçëáíáçå
On the Input Position Menu, select V Position to adjust (in lines) the start of the input
video's active area from V sync.
s=páòÉ
On the Input Position Menu, select V Size to adjust (in lines) the size of the active area.
p~îÉ=`çåÑáÖ
From the Input Position Menu, select Save Config to display the Save Config As Menu,
which allows you to save and name up to 64 input configurations.
S A V E C O N F I G A S
> File1
Figure 4-89. Save Config As Menu (sample)
Please note the following important points regarding input configurations:
•
•
To save an input configuration:
1.
2.
3.
4.
LED-PRO • User's Guide
Save Con fig
Note
This function is the same as the Save Config function located
in the Input Setup Menu (SETUP > Expert Mode > Input).
It is also located here for operator convenience.
When you save input configuration parameters, they are stored in non-volatile
memory for each input source. If you do not save the parameters, the information
will not be restored upon the next system power up sequence.
A filename may include up to 19 characters.
Scroll to the filename field (e.g., File1) and press SEL. The navigation cursor (>)
changes to the edit cursor (#), allowing you to edit the first character.
Choose a character by turning the knob, and "accept" it by pressing SEL. This
action also selects the next character for editing.
Repeat step 2 for all desired characters.
When data entry is complete, press SEL again. The filename will be truncated up
to the current character position.
4. Operation
Using the Input Position Menu
107
Advertisement
Table of Contents
