Blaster Alert; Route Table - Planet MH-4000 User Manual

Enable this function to detect such abnormal packets.
After enabling the needed detect functions, click OK to activate the changes.

4.1.6 Blaster Alert

The Administrator can enable the device's auto detect functions for blaster worm attacking the local network.
When abnormal conditions occur, MH-2K/4K will send an e-mail alert and/or SNMP trap to notify the
Administrator, and also display warning messages in the Blaster window of Alarm.
Blaster Alerts Settings
Enable Blaster Blocking: Select this option to enable the blaster blocking function. Once
the blaster worm is detected, it will block the TCP port 135 for user-drefined blocking time.
Enable E-mail Alert Notification: When Blaster worm is detected, send alert e-mail to
administrator by using e-mail address defined on System -> Setting.
Enalbe SNMP Trap Alert Notification: When Blaster worm is detected, send SNMP trap to
user-defined SNMP trap receiver IP address defined on System -> SNMP (MH-4000 only).
Enable NetBIOS Alert Notification: When Blaster worm is detected, send alart message
to administrator by using "Net send" command (MH-4000 only).
After enabling the needed options, click OK to activate the changes.

4.1.7 Route Table

In this section, the Administrator can add static routes for the networks.
Entering the Route Table screen
Step 1. Click System on the left side menu bar, then click Route Table below it. The Route Table
window appears, in which current route settings are shown.
Multi-Homing Security Gateway User's Manual
- 31 -