Configure Wan 2 Interface; Configure Dmz Interface; Configure Policy - Planet MH-4000 User Manual

Multi-Homing Security Gateway User's Manual
WebUI: Select this to allow the device WebUI to be accessed from the WAN network. This will allow the
WebUI to be configured from a user on the Internet. Keep in mind that the device always requires a username
and password to enter the WebUI.

3.3 Configure WAN 2 interface

If you want to connect WAN 2 to another ISP connection, click Modify button of WAN No. 2 then repeat above
procedures to setup.

3.4 Configure DMZ interface

Depends on your network requirement, you can disable the DMZ port, make DMZ port transparent to WAN 1 or
enable NAT function on it.
To configure the DMZ port, select the Interface tab on the left menu, then click on DMZ, the following page is
shown.
Please refer to section 3 for select the mode you need and configure relative IP parameters.

3.5 Configure Policy

STEP 1:
Click on the Policy tab from the main function menu, and then click on Outgoing (LAN to WAN) from the
sub-function list.
STEP 2:
Click on New Entry button.
STEP 3:
When the New Entry option appears, enter the following configuration:
Source Address – select "Inside_Any"
- 10 -