Draytek VigorPro 5510 Series User Manual page 67

Enable
Mode
Service Name
Protocol
WAN Interface
Public Port
Private IP
Private Port
Active
Note that the router has its own built-in services (servers) such as Telnet, HTTP and FTP etc.
Since the common port numbers of these services (servers) are all the same, you may need to
reset the router in order to avoid confliction.
For example, the built-in web configurator in the router is with default port 80, which may
conflict with the web server in the local network, http://192.168.1.13:80. Therefore, you need
to change the router's http port to any one other than the default port 80 to avoid
conflict, such as 8080. This can be set in the System Maintenance >>Management Setup.
VigorPro5510 Series User's Guide
Check this box to enable such port redirection setting.
Two options (Single and Range) are provided here for you to
choose. To set a range for the specific service, select Range. In
Range mode, if the public port (start port and end port) and the
starting IP of private IP had been entered, the system will calculate
and display the ending IP of private IP automatically.
Enter the description of the specific network service.
Select the transport layer protocol (TCP or UDP).
Chose the WAN interface for applying port redirection. The default
setting is All which means all the incoming data from any port will
be redirected to WAN1 and WAN2 at the same time.
Specify which port can be redirected to the specified Private IP
and Port of the internal host. If you choose Range as the port
redirection mode, you will see two boxes on this field. Simply type
the required numbers on these two boxes.
Specify the private IP address of the internal host providing the
service. If you choose Range as the port redirection mode, you will
see two boxes on this field. Simply type the IP address in the first
box (as the starting point). The second one is assigned
automatically after you type the private port number below.
Specify the private port number of the service offered by the
internal host. After you enter the proper number in this box, the
second box of Private IP address will be assigned accordingly.
Check this box to activate the port-mapping entry you have
defined.
57