Table of Contents
Advertisement
Installation Instructions
............................................................................................................................................................................................................................................................
Initial configuration
At this point in the installation, you should be able to use OmniTouch ACS's Web
Administration Interface to complete your server's initial configuration.
To connect to the server from a browser on another
computer
........................................................................................................................................................................................................................
Go to another computer that has access to OmniTouch ACS. Open a browser window.
1
........................................................................................................................................................................................................................
In the address line, type in the hostname.domain.ext you assigned to the OmniTouch ACS
2
server, followed by /admin,
(for example,
A login screen is displayed:
Figure 3-15 Web Administration Interface Login
If the login screen does not appear, the most likely cause is that the server is not connected
correctly to the network. You should try the following:
•
•
•
........................................................................................................................................................................................................................
Log into the server's Web Administration Interface using the same Login ID and Password
3
that you used when logging into the Serial Console. The default is:
Login:
Password:
............................................................................................................................................................................................................................................................
8AL90213USAC ed 01
September 12, 2008
ht tp s :/ /y o ur s er ve r 1. yo u rc o mp an y .c om / ad m in
Check that the server's primary Ethernet port (eth0) is correctly connected to the
LAN.
Be sure that the computer that you are using for management has access to the
server's LAN.
Validate that both the cable and the LAN's Ethernet port where you have
connected the server are functioning.
admin
changeme
Initial configuration
).
3 - 1 3
Advertisement
Table of Contents
