Table of Contents
Advertisement
Setting time and date
[Time and date setting]
Set the time and date of the system, used for chime schedule
and transfer schedule.
1
Click
Time and date setting in the table of contents.
2
Set the following settings.
•
Required
[Set current time]
Set the current time and date in one of the following
methods.
•
Input the current time and date manually, and then
click Manual setting .
Synchronized with PC to set the current time
•
Click
and date by making it synchronized with the PC.
•
You can also set the current time and date by
synchronized with NTP server [Synchronized with NTP
server] as shown below.
If there is no power supply to the system for a long
*
time because of power failure etc., the time and date
setting may be cleared.
•
[NTP (Network Time Protocol)]:
Set [Synchronized with NTP server] to ON to set the
current time and date by making it synchronized with
NTP server. Then set the [NTP server] and [NTP port
number].
[NTP server]:
*
Enter the IP address or domain name of the NTP
server to be used as the master clock.
•
[UTC time zone]:
Set the time differences from Coordinated Universal
Time (UTC). Set the [Hour difference] and [Minute
difference] respectively.
•
[Synchronize interval]:
Set the time data acquisition interval (hour) from the
NTP server, and the interval of synchronization with
the system.
•
[Daylight savings time]:
Set whether to utilize daylight savings time (ON) or
(OFF). When set to ON, then set the start and end
times (Month, Week of the month, Day of the week,
Hour and Minute), and time differences (Hour and
Minute).
It is recommended to connect the system with a PC or
*
NTP server constantly to keep the correct time and date
setting.
3
Click
Temporarily stored
results temporarily.
*
If you wish to cancel the setting results you have made,
click a title in the table of contents or "Refresh" in the
web browser menu.
22
:
making it
to save the current setting
Downloading/uploading setting data
[Setting fi le]
You can download the setting data you have made into a fi le
and save it on the PC. On the contrary, you can upload the
setting data from the PC.
It is recommended to download the setting data as a backup
*
copy after you fi nish making settings or setting changes.
■ When downloading setting data onto the PC
1
Click
Downloading setting data in the table of
contents.
2
Click
to download the current setting data
Download
into a fi le.
NOTE:
MP3-format sound fi les registered at [Chime setting – Registering
sound source] will not be downloaded from the system by this
operation.
It is recommended that you also save the registered MP3 fi les
separately.
■ When uploading setting data
1
Click
Uploading setting data in the table of contents.
2
Click
to upload the setting data from the PC
Upload
to the system.
You can select the setting data fi le from another window,
and upload it.
3
Update the system.
Refer to "Updating the system" below.
*
NOTE:
Uploading the setting data will overwrite the current data.
Upload sound fi les separately to register them as the internal
*
sound sources.
Updating the system [Updating the system]
Update the system with the setting data you have entered
(currently stored temporarily).
1
Click
Updating the system in the table of contents.
2
Click
to update the system with the setting
Update
data currently stored temporarily.
NOTE:
Do not turn off the system while updating the system.
Advertisement
Table of Contents
