Initial Set-Up; Setting The Current Date And Time [General] - [Date/Time]; Changing The Display Language [General] - [Language] - Aiphone JM-4MED Operation Manual

INITIAL SET-UP

Setting the current date and time
[GENERAL] - [DATE/TIME]
When this station is powered up for the fi rst time or after this
station is rebooted, set the current date and time.
1
If screen is off, press the [HOME] button, or touch
screen to turn it on.
2 When the message, "SET CURRENT DATE AND
TIME." is displayed, touch SETTING .
3 Set the month, date, year, hour, and minute
individually by touching
Month Date Year
Touch and hold or
*
4
When the setting has fi nished, touch
5 Press the [HOME] button to display the HOME
window.
To correct date and time
You can correct the current date and time any time by following
the procedue below.
1
From HOME window, touch
→
GENERAL DATE/TIME .
2 Set the month, date, year, hour and minute
individually by touching
3
When the setting has fi nished, touch
or
or .
Hour Minute
to increase speed.
ENTER .
SETTINGS →
or .
ENTER .
NOTES:
A maximum of 60 seconds time gain/loss can occur in the
•
displayed time over a month. It is recommended to correct the
time periodically.
If there is no power supply for 30 minutes or more, the date and
•
time return to default.
Changing the display language
[GENERAL] - [LANGUAGE]
The display language for the screen is set to English as default.
First change it to the language you need as follows.
This setting is also applied to all sub master stations in this
*
system.
1
From HOME window, touch SETTINGS
LANGUAGE .
→
GENERAL
2 Touch desired language until highlighted and select
ENTER .
If the target language is not found in the window, touch
*
or .
→
9