Table of Contents
Advertisement
ABORt
Subsystem Syntax
Comments
Example
50 E1463A Command Reference
The ABORt command stops a scan in progress when the scan is enabled
via the interface and the trigger source is TRIGger:SOURce BUS or
TRIGger:SOURce HOLD.
ABORt
The ABORt command terminates the scan and invalidates
ABORt Actions:
the current channel list.
Stopping Scan Enabled Via Interface:
interface, an interface CLEAR command can be used to stop the scan.
When the scan is enabled via the interface and TRIG:SOUR BUS or HOLD
is set, you can use ABORt to stop the scan.
ARM, INITiate:CONTinuous,[ROUTe:]SCAN, TRIGger
Related Commands:
Stopping a Scan with ABORt
This example stops a continuous scan in progress.
TRIG:SOUR BUS
INIT:CONT ON
SCAN(@100:107)
INIT
.
.
ABOR
When a scan is enabled via an
!Trigger command will be via
backplane (bus) interface (*TRG
command generates trigger)
!Set continuous scanning
!Scan channels 00 to 07
!Start scan, close channel 00
!Abort scan in progress
Chapter 3
Advertisement
Table of Contents
