Chapter 5 Access Management; Overview; Slid Screen - ZyXEL Communications PMG1005-T20B User Manual

5.1 Overview

• Use the SLID screen to change your GPON Device's Subscriber Location ID (SLID) setting
on page

5.2 SLID Screen

To change your GPON Device's Subscriber Location ID (SLID) setting, click Access Management > Auth.
The screen appears as shown. The SLID identifies your device to the GPON service provider's Optical
Line Terminal (OLT). If your GPON service provider gave you an SLID to use, enter it in this screen.
Figure 11 Access Management > Auth
The following table describes the fields in this screen.
Table 8 Access Management > Auth
LABEL
SLID
APPLY
Access Management
21).
DESCRIPTION
Enter the SLID used for gaining access to the service provider's network. It is case-sensitive,
so make sure [Caps Lock] is not on.
Click APPLY to save your changes back to the GPON Device.
PMG1005-T20B User's Guide
C
H A P T E R
21
5
(Section 5.2