Electrical Connections; Power Inlet; Figure 2-9: Model 7600 Electrical Connections - Teledyne 7600 Operating Instructions Manual

Installation

2.6 Electrical Connections

2.6.1 Power Inlet

The power inlet for the Model 7600 is located on the rear panel as
shown in Figure 2-9. The proper 3-prong power cord has been supplied
with your instrument. Connect the power cable to the power inlet.

Figure 2-9: Model 7600 Electrical Connections

The Model 7600 requires 100-240 VAC 50/60 Hz power.
Avoid installing this instrument near an electrical unit that
generates electrical noise such as a high frequency furnace or electric
welder. If using the instrument near such a noise-generating unit is
unavoidable, use a separate power line to avoid noise.
Mount a noise suppressor such as varister or spark killer as shown
in Figure 2-10 to the noise generating unit when noise is generated from
relays or solenoid valves. The suppressor must be mounted near the
noise generating source, or it will have no effect.
Teledyne Analytical Instruments
Model 7600
32