Linearization; Changing Stream; Setting Up An Auto-Cal - Teledyne 4060 Series Instruction, Operating And Maintenance Manual

Operation
______________________________________________
______________________________________________

4.6.12 Linearization

Not applicable to the 4060 configuration.

4.6.13 Changing Stream

Affects the relay on the rear panel that controls which gas is allowed
to flow to the column and detector.
When the instrument has electronically controlled calibration valves
(option), the gas stream can be switched here. You can flow span,
sample (or zero gas) without entering the calibration mode in order to
check instrument response. During a span calibration, the span stream is
activated. After a span calibration, the sample stream is activated
regardless of what was set before the span.

4.6.14 Setting up an AUTO-CAL

The Series 4060 Analyzer can be fitted with an external auto
calibration module as an option. This feature provides automatic
switching of sample and calibration gases and allows the operator to
program calibration events to occur automatically
Note: If your instrument is not fitted with an autocal module, the
autocal screens will still appear on the display but will be
non-functional.
Note: Before setting up an AUTOCAL, be sure you understand
Teledyne Analytical Instruments
56
-> CH1 Offset
CH1 Gain
CH1 (Wave, Id for Ch2, or Group Output)
CH1 (Select Groups)
CH2 (Wave, Id for Ch2, or Group Output)
CH2 (Select Groups)
Series 4060