Logout; System Self-Diagnostic Test - Teledyne 3010TA Operating Instructions Manual

Oxygen Analyzer
If no alarms are tripped, the Analyze screen appears as:
If an alarm is tripped, the second line will change to show which alarm
it is:
NOTE:If you previously logged off the system , you will now be
required to re-enter the password to gain access to Span,
Zero, Alarm, and Range functions.

4.3.4 Logout

The
analyzer in a password protected mode without having to shut the instrument
off. By entering
system protected against use until the password is reentered. To log out,
press the System button to enter the System function.
Use the < > arrow keys to position the blinking over the
tion, and press Enter to Log out. The screen will display the message:

4.3.5 System Self-Diagnostic Test

The Model 3010TA has a built-in self-diagnostic testing routine. Pre-
programmed signals are sent through the power supply, output board and
sensor circuit. The return signal is analyzed, and at the end of the test the
status of each function is displayed on the screen, either as
number between 1 and 3. (See System Self Diagnostic Test in chapter 5 for
number code.)
Note: Remote Probe connector must be connected to the Analysis
Unit, or sensor circuit will not be properly checked.
The self diagnostics are run automatically by the analyzer whenever the
instrument is turned on, but the test can also be run by the operator at will.
To initiate a self diagnostic test during operation:
function provides a convenient means of leaving the
, you effectively log off the instrument leaving the
Part I: Control Unit
func-
or as a
Part I: 4-9