Maintenance; Fuse Replacement - Teledyne 3010TA Operating Instructions Manual

Part I: Control Unit
Aside from normal cleaning and checking for leaks at the gas connec-
tions, routine maintenance is limited to replacing Micro-Fuel cells and fuses,
and recalibration.
Checking for leaks, replacing Micro-Fuel cells, and replacing fuses in
the Analysis Unit are covered in Part II, Chapter 5. For recalibration, see
Part I, section 4.4 Calibration.
WARNING: SEE WARNINGS ON THE TITLE PAGE OF THIS
5.1
1. Place small screwdriver in notch, and pry cover off, as shown in
Figure 5-1.
2. To change between American and European fuses, remove the
single retaining screw, flip Fuse Block over 180 degrees, and
replace screw.

Maintenance

MANUAL.

Fuse Replacement

Figure 5-1: Removing Fuse Block from Housing
Maintenance 5
Part I: 5-1