Installing Or Changing The Password - Teledyne 3010MB Operating Instructions Manual

Percent Paramagnetic Oxygen Analyzer
is in effect, pressing the ENTER button will enter the default
word for you.
Press System to enter the System mode.
Use the < > arrow keys to scroll the blinking over to
Enter to select the password function. Either the default
place holders for an existing password will appear on screen
depending on whether or not a password has been previously installed.
The screen prompts you to enter the current password. If you are not
using password protection, press Enter to accept
password. If a password has been previously installed, enter the password
using the < > arrow keys to scroll back and forth between letters, and the
arrow keys to change the letters to the proper password. Press Enter to enter
the password.
If the password is accepted, the screen will indicate that the password
restrictions have been removed and you have clearance to proceed.
In a few seconds, you will be given the opportunity to change this
password or keep it and go on.
Press Escape to move on, or proceed as in Changing the Password,
below.
If you want to install a password, or change an existing password,
proceed as above in Entering the Password. When you are given the oppor-
tunity to change the password:
or
4.3.3.2

Installing or Changing the Password

Teledyne Analytical Instruments
Part I: Control Unit
pass-
, and press
password or
as the default
Part I: 4-7