Table of Contents
Advertisement
4 Operation
Use < > arrows to blink
set appears.
Press < > arrows to blink
won't be able to set
... (or
Use
arrows to set an interval value, then use < > arrows to move to
the start-time value. Use
To turn
the
System again, choose
values screen appears, use the < > arrows to blink the
field. Use
now turn these fields
4.3.3 Password Protection
If a password is assigned, then setting the following system parameters
can be done only after the password is entered: span and zero settings,
alarm setpoints, analysis range definitions, switching between autoranging
and manual override, setting up an auto-cal, and assigning a new password.
However, the instrument can still be used for analysis or for initiating a self-
test without entering the password.
If you have decided not to employ password security, use the default
password
. This password will be displayed automatically by the
microprocessor. The operator just presses the Enter key to be allowed total
access to the instrument's features.
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.
4.3.3.1
To install a new password or change a previously installed password,
you must key in and ENTER the old password first. If the default password
4-6: Part I
, and press Enter . A new screen for
), then press Enter again. (You
(or
to
if a zero interval is entered.) A
...) screen appears.
arrows to set a start-time value.
and/or
cycles (to activate
and press Enter again. When the
,
arrows to set the
because there is a nonzero span interval defined.
Entering the Password
Teledyne Analytical Instruments
Model 3010MB
): Press
(or
field to
. You can
)
Advertisement
Table of Contents
