Korg D1600mkII Owner's Manual page 72

5. Verify the results.
Press the [IN/LOC1] key to play back from the IN
location, and verify that the data was deleted
correctly.
You can use Undo to return to the state before execut-
ing the command.
Reversing track data: Reverse Track
The Reverse Track command copies a reversed version of
the specified region (IN–OUT) of recorded track data to
the TO location of another track.
• The IN–OUT region can be copied not just once, but
multiple times in succession.
• Data can be copied not only from one track, but from
multiple tracks simultaneously.
Procedure for reversing track data (Reverse)
Here's how to reverse the IN–OUT region of track 1, and
copy it three times to the TO location of track 2.
1. Register the IN, OUT, and TO times.
2. Select the Reverse command.
In the [TRACK] "EditTrk" tab page, set "EditType" to
"ReverseTrack."
SourceTrack
3. Select the reverse source track number.
Set "SourceTrack" to track 1.
4. Select the reverse destination track number.
Set "DestTrack" to track 2.
5. Specify the number of times the data will be copied.
Set "Times" to 3.
6. Execute the editing command.
Press the "Exec." button.
The display will ask "AreYouSure?," so press the
"Yes" button to execute the command.
When processing is completed, the display will
indicate "Completed." Press the "OK" button.
7. Verify the results.
Press the [TO/LOC3] key to play back from the TO
location, and verify that the data was edited correctly.
You can use Undo to return to the state before execut-
ing the command.
The longer the specified range (IN–OUT), the longer
this command will take to process until the
"Completed" display appears.
64
DestTrack Times
Optimizing track data: Optimize Track
This operation optimizes the specified region (IN–OUT)
of recorded track data.
If you repeatedly record or edit short intervals of time,
the data on the hard disk will become fragmented,
requiring the D1600mkII to access the disk more
frequently, and making it more likely that skips will be
heard or that the "DiskBusy" message will appear,
possibly making it impossible to play back correctly. In
such cases, you can optimize the fragmented region so
that it will play back correctly.
Optimizing track data
Here's how to optimize the IN–OUT region of track 1.
1. Store the IN and OUT locations.
Set IN at a point slightly ahead of where the "Disk-
Busy" messages begin appearing, and OUT to a point
at which these messages no longer appear.
2. Select the Optimize command.
In the [TRACK] "EditTrk" tab page, set "EditType" to
"OptimizeTrack."
DestTrack
3. Select the track number that you want to optimize.
Find the track where you suspect that the data is frag-
mented (here we will assume that track 1 is the prob-
lem), and specify "DestTrack" as track "1".
4. Execute the operation.
Press the "Exec." button.
The display will ask "AreYouSure?" Press the "Yes"
button to execute the operation.
When the operation is completed, the display will
indicate "Completed." Press the "OK" button.
5. Check the results.
Press the [IN/LOC1] key and play back from the IN
location. If playback occurs correctly without the
"Disk Busy" message appearing, the optimization
was successful.
You can use Undo to return to the state prior to
execution.
This operation will require a longer time for comple-
tion in proportion to the length of the specified region
(IN–OUT).