Korg D1600mkII Owner's Manual page 154

mon use of this effect is to produce the sound of various instru-
ments by inputting a voice to the Modulator via a microphone.
A special effect is also achieved by using rhythm or effect
sounds. Strings or distortion guitar sounds with a lot of harmon-
ics are suitable as a Carrier.
146
Carri (L [Carrier] Trim) ............ 0...100 Sets the input level of left channel
Modul (R [Modulator] Trim) .... 0...100 Sets the input level of right chan-
Formnt (Formant Shift)........... –2...+2 Sets the height of the frequency
Respo (Response) ................. 0...100 Sets the speed of the response
NLevel (Noise Level) .............. 0...100 Sets the noise mix level to the
LoGain (Low Gain [dB]) ..... –12...+12 Sets the low-range output level of
HiGain (High Gain [dB]) ..... –12...+12 Sets the high-range output level
HiMix (Modulator High Mix) ... 0...100 Sets the high-range output level
Bal (Vocoder/Carrier) ............ Carrier,
1:99...99:1,
Vocode
Mix (Wet/Dry) ....Dry, 1:99...99:1, Wet Sets the balance between the
: Formant Shift
By offsetting the Carrier filter, you can adjust the height of the fre-
quency range to which the vocoder effect is applied. The tonal qual-
ity will change significantly.
: Noise Level
This parameter enables you to mix white noise with the Carrier.
: Modulator High Mix
This parameter sets the high-range output level of the right channel
sound (Modulator). If the modulator is a human voice, it will make
the words more clear.
: Vocoder/Carrier, : Wet/Dry
The "Vocoder/Carrier" parameter sets the balance between the
vocoder sound and the left channel sound (Carrier). The "Wet/Dry"
parameter sets the balance between the effect and dry sound. If you
wish to change the intensity of the vocoder effect, select "Wet" for
"Wet/Dry", and adjust the balance using the "Vocoder/Carrier"
parameter.
35: LS4: St.Pitch Shifter
(Stereo Pitch Shifter)
This is a stereo pitch shifter. The pitch shift amount for the left
and right channels can be reversed from each other.
Mode (Mode) ..... Slow, Medium, Fast Switches Pitch Shifter mode
L/R (L/R Pitch) ........Normal, Up/Dwn Determines whether or not the L/
*Pitch (Pitch Shift [1/2tone]) –24...+24 Sets the pitch shift amount in
Fine (Fine [cent]).......... –100...+100c Sets the pitch shift amount in
LDly (Lch Delay [msec])....... 0...1000 Sets the delay time for the left
RDly (Rch Delay [msec])...... 0...1000 Sets the delay time for the right
FPoint (Feedback Position) .Pre, Post Switches the feedback connec-
Fdback (Feedback) ........ –100...+100 Sets the feedback amount
HiDamp (High Damp [%]) ...... 0...100 Sets the damping amount in the
Spread (Spread) ............ –100...+100 Sets the width of the stereo
Mix (Wet/Dry) ....Dry, 1:99...99:1, Wet Sets the balance between the
: L/R Pitch
When you select "Up/Dwn" for this parameter, the pitch shift
amount for the right channel will be reversed. If the pitch shift
amount is positive, the pitch of the left channel is raised, and the
pitch of the right channel is lowered. If an expression pedal etc. is
used to control the pitch, the pitch of the left channel will be con-
trolled.
(Carrier)
nel (Modulator)
for the vocoder effect
to the modulator input
Carrier
the vocoder
of the vocoder
of the modulator
Sets the balance between the
vocoder output and the Carrier
effect and dry sounds
R pitch shift amount is inverted
steps of a semitone
steps of one cent
channel
channel
tion
high range
image of the effect sound
effect and dry sounds