Korg D1600mkII Owner's Manual page 163

Comp2
(Compressor2)
This effect adds Pre LEQ and Pre HEQ to Comp1.
Sense (Sensitivity) ................. 1...100 Sets the sensitivity
Attack (Attack)........................ 1...100 Sets the attack level
Trim (EQ Trim) ........................ 0...100 Sets the EQ input level
LEQG (Pre HEQ Gain [dB])–15...+15 Sets the gain of High EQ
HEQG (Pre LEQ Gain [dB])–15...+15 Sets the gain of Low EQ
Level (Output Level) ............... 0...100 Sets the output level of the com-
Lmtr
(Limiter)
Ratio (Ratio)........ 1.0:1...50.0:1, Inf:1 Sets the signal compression ratio
Thrshl (Threshold [dB]) .......... –40...0 Sets the level above which the
Attck (Attack).......................... 1...100 Sets the attack time
Relse (Release) ..................... 1...100 Sets the release time
GLevel (Gain Adjust [dB]) ....... –Inf, –
38...+24
AmpSim
(Amp Simulator)
Type (Amplifier Type).. SS, EL84, 6L6 Selects the type of guitar ampli-
MicSim
(Mic Simulator)
Refer to p.152.
Decima
(Decimator)
LPF (Pre LPF)........................Off, On Selects whether the harmonic
Fs (Sampling Frequency [Hz]) ..........
1.0k...44.1k
Bit (Resolution) ........................ 4...24 Sets the data bit length
HiDamp (High Damp [%]) ...... 0...100 Sets the ratio at which the high
Level (Output Level) ............... 0...100 Sets the decimator output level
ODHiG
(OverDrive/HighGain)
Mode (Drive Mode)
............ OD(Overdrive), HiG(Hi-Gain)
*Drive (Drive)........................... 1...100 Sets the degree of distortion
Level (Output Level) ................. 0...50 Sets the overdrive output level
LoFc (Low Cutoff [Hz]) .... 20Hz...1.0k Sets the center frequency for Low
LoG (Gain [dB]).................. –18...+18 Sets the gain of Low EQ
Md1Fc (Mid1 Cutoff [Hz])
.................................... 300Hz...10.0k
Md1Q (Q) ........................... 0.5...10.0 Sets the band width of Mid/High
Md1G (Gain [dB])............... –18...+18 Sets the gain of Mid/High EQ 1
Md2Fc (Mid2 Cutoff [Hz])
.................................... 500Hz...20.0k
Md2Q (Q) ........................... 0.5...10.0 Sets the band width of Mid/High
Md2G (Gain [dB])............... –18...+18 Sets the gain of Mid/High EQ 2
ChFl1
(Chorus/Flanger1)
DTime (Delay Time [msec]) 0.0...50.0 Sets the delay time
LFO (LFO Waveform).......... TRI, SIN Selects LFO Waveform
*Speed (Frequency [Hz]) ... 0.02...20.0 Sets the LFO speed
*Depth (Depth) ........................ 0...100 Sets the depth of LFO modula-
Fdback (Feedback) ........ –100...+100 Sets the feedback amount
Mix (Wet/Dry) ........–Wet...–1:99, Dry,
1:99...Wet
pressor
compressor is applied
Sets the limiter output gain
fier
noise caused by a decrease in
sampling frequency is generated
Sets the sampling frequency
range is cut
Switching between overdrive and
hyper-gain mode
EQ (shelving type)
Sets the center frequency for
Mid/High EQ 1 (peaking type)
EQ 1
Sets the center frequency for
Mid/High EQ 2 (peaking type)
EQ 2
tion
Sets the effect balance of the
chorus/flanger
ChFl2
(Chorus/Flanger2)
DTime (Delay Time [msec]) 0.0...50.0 Sets the delay time
LFO (LFO Waveform) .......... TRI, SIN Selects LFO Waveform
*Speed (Frequency [Hz]) ...0.02...20.0 Sets the LFO speed
*Depth (Depth).........................0...100 Sets the depth of LFO modula-
Fdback (Feedback).........–100...+100 Sets the feedback amount
EQTrim (EQ Trim) ...................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) –15...+15 Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB])–15...+15 Sets the gain of High EQ
Mix (Wet/Dry) ....... –Wet...–1:99, Dry,
1:99...Wet
Phaser
LFO (LFO Waveform) .......... TRI, SIN Selects LFO Waveform
*Speed (LFO Frequency [Hz]) ............
0.02...20.0
Manual (Manual) ....................0...100 Sets the frequency to which the
*Depth (Depth).........................0...100 Sets the depth of LFO modula-
Reso (Resonance) .........–100...+100 Sets the resonance amount
Mix (Wet/Dry) ....... –Wet...–1:99, Dry,
1:99...Wet
Trml
(Tremolo)
LFO (LFO Waveform) ......... TRI, SIN,
Vintage, Up, Down
Shape (LFO Shape) .......–100...+100 Determines how much the LFO
*Speed (LFO Frequency [Hz]) ............
0.02...20.0
*Depth (Depth).........................0...100 Sets the depth of LFO modula-
Mt.Dly
(Multitap Delay)
T1Time (Tap1 Time [msec])....0...680 Sets the Tap1 delay time
T2Time (Tap2 Time [msec])....0...680 Sets the Tap2 delay time
T1Lvl (Tap1 Level) ..................0...100 Sets the Tap1 output level
Fdback (Feedback).........–100...+100 Sets the Tap2 feedback amount
HiDamp (High Damp [%]).......0...100 Sets the damping amount in the
Mix (Wet/Dry) ... Dry, 1:99...99:1, Wet Sets the effect balance of the
Reverb
(Mono Reverb)
Time (Reverb Time [sec]) ...0.1...10.0 Sets the reverberation time
HiDamp (High Damp [%])....0...100% Sets the damping amount in the
PreDly (Pre Delay [msec])......0...200 Sets the delay time of the reverb
EQTrim (EQ Trim) ...................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) –15...+15 Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB])–15...+15 Sets the gain of High EQ
RevBal (Reverb Balance) ............Dry,
1:99...99:1,
Wet
Gate
Contrl (Input Reverb Mix) ............Dry,
1:99...99:1,
Wet
Polrty (Polarity) ............................+, – Switches between non-reversed
Thrshl (Threshold) ..................0...100 Sets the level to which the Gate
tion
Sets the effect balance of the
chorus/flanger
Sets the LFO speed
effect is applied
tion
Sets the phaser effect balance
Selects LFO Waveform
waveform is changed
Sets the LFO speed
tion
high range
multi-tap delay
high range
sound and gate control signal
Sets the effect balance of the
reverb
Sets the balance between the dry
and reverb sounds of the gate
control signal
and reversed Gate on/off
is applied
155