Korg D1600mkII Owner's Manual page 15

7 [AUX OUT] jack
Connect this to the input jack of an external effect
device.
This jack outputs the external send signal from each
mixer channel. This is a 1/4" phone jack.
8 [MONITOR OUT L/R] jacks
Connect your external monitor system to these jacks.
The bus that is sent to the monitor output is selected
in the [SOLO/MONITOR] "Monitor" tab page.
These jacks output the same audio signal as
[PHONES].
This is a 1/4" phone jack.
9 [MASTER OUT L/R] jacks
These are analog outputs for the master LR bus which
combines the signals from each mixer channel, or for
the audio source that is selected by the Solo function.
The Solo selection is made in the [SOLO/MONITOR]
"Solo" tab page.
Connect your external monitor system or recording
device to these jacks. They output the same audio sig-
nal as the [S/P DIF OUT] jacks.
This is a 1/4" phone jack.
10 [S/P DIF OUT] jack
This is an optical-type S/PDIF format (IEC60958,
EIAJ CP-1201) digital output jack (stereo).
Use an optical cable to connect this jack to the optical
digital input of your DAT or MD.
This jack digitally outputs the same audio signal as
the [MASTER OUT L/R] jacks at a sampling rate of
44.1 kHz.
11 [S/P DIF IN] jack
This is an optical-type S/PDIF format (IEC60958,
EIAJ CP-1201) digital input jack (stereo).
Use an optical cable to connect this jack to the optical
digital output of your DAT or MD.
A sampling rate converter is built in. If the connected
source has a sampling rate of 48 kHz or 32 kHz
source, it will be converted automatically to 44.1 kHz.
12 [USB] connector
Use a USB cable to connect this to your computer.
You cannot connect USB peripheral devices such
as an external hard disk or CD-R/RW drive to
the D1600mkII.
13 [LCD CONTRAST] knob
This adjusts the contrast of the LCD screen.
The optimal setting will depend on the viewing
angle, so adjust the contrast as necessary. Looking
from the front panel, turning the knob toward the
right will darken the text, and turning it toward the
left will lighten the text.
14 [MIDI OUT] connector
MIDI messages are transmitted from this connector.
Use this when you wish to control a connected exter-
nal MIDI device from the D1600mkII.
15 [MIDI IN] connector
MIDI messages are received at this connector. Use
this when you wish to control the D1600mkII from a
connected external MIDI device.
7