Amp Lfo1; Amp Lfo2; Amp Eg; Page 14 ‐ Amp Lfo1 - Korg microARRANGER Owner's Manual

118 Program operating mode
Page 14 - Amp LFO1
Amplifier Modulation
These parameters specify how the volume of the
selected oscillator will be affected by velocity.
Velocity Intensity
With positive (+) values, the volume will increase as
you play more strongly. With negative (–) values, the
volume will decrease as you play more strongly.
Volume change (with positive (+) values of this parameter)
Note-on
Note-off
Softly played
‐99...+99 Intensity value.
EG AMS (Alternate Modulation Source)
Selects the source that will control the volume of the
amp for the selected oscillator (See "AMS (Alternate
Modulation Source) list" on page 123). "Velocity" can‐
not be selected.
Intensity
This parameter specifies the depth and direction of the
effect that "AMS" will have. The actual volume will be
determined by multiplying the value of the changes
produced by the amp EG with the values of Alternate
Modulation etc., and if the levels of the amp EG are
low, the modulation applied by Alternate Modulation
will also be less.
For example, if "AMS" is set to Joystick +Y, positive (+)
values of this parameter will cause the volume to
increase when you push the joystick. However if the EG
settings etc. have already raised the volume to its maxi‐
mum level, the volume cannot be increased further.
With negative (–) values of this parameter, the volume
will decrease when the joystick is pushed.
‐99...+99 Intensity value.
PAGE 14 - AMP LFO1
These parameters let you use "LFO1" (see "Page 17 ‐
LFO1" on page 120) and "LFO 2" (see "Page 18 ‐ LFO2" on
page 122) to control the volume of the selected oscillator.
Selected
Use this parameter to select an oscillator to put in edit.
Alternatively, you can select oscillators using the F‐1–F‐
4 buttons.
Note-on
Note-off
Strongly played
Intensity
This parameter specifies the depth and direction of the
effect that "LFO1" will have on the volume of the
selected oscillator. Negative (–) values will invert the
LFO waveform.
‐99...+99 Intensity value.
Amplifier LFO1 modulation
AMS (Alternate Modulation Source)
Use this parameter to select a source that will control
the depth by which "LFO1" will modulate the volume
of the selected oscillator. See "AMS (Alternate Modula‐
tion Source) list" on page 123.
Intensity
As the absolute value of this setting is increased, the
effect of "AMS" on "LFO1" will increase. Negative (–)
values will invert the LFO waveform.
‐99...+99 Intensity value.
PAGE 15 - AMP LFO2
These parameters let you use "LFO1" (see "Page 17 ‐
LFO1" on page 120) and "LFO 2" (see "Page 18 ‐ LFO2"
on page 122) to control the selected oscillator volume.
See "Page 14 ‐ Amp LFO1" for more information on
parameter's editing.
PAGE 16 - AMP EG
These parameters let you create time‐varying changes
in the volume of the selected oscillator.
Selected
Use this parameter to select an oscillator to put in edit.
Alternatively, you can select oscillators using the F‐1–F‐
4 buttons.