Stereo Envelope Flanger; Stereo Random Flanger - Korg microARRANGER Owner's Manual

188 Effects
Pitch/Phase Mod.
tive value for both "Feedback" and "Wet/Dry", and if you set a
negative value for both "Feedback" and "Wet/Dry".
g: High Damp [%]
This parameter sets the amount of damping of the feedback
in the high range. Increasing the value will cut high-range har-
monics.
021: RandomFlang

(Stereo Random Flanger)

The stereo effect uses a step‐shape waveform and ran‐
dom LFO for modulation, creating a unique flanging
effect.
Stereo In - Stereo Out
Left
Right
LFO: Step-Tri/Random
Delay Time [msec]
a
Sets the delay time from the original sound
LFO Waveform
b
Selects LFO Waveform
LFO Phase [degree]
c
Sets the LFO phase difference between the left and right
LFO Frequency [Hz]
Sets the LFO speed
Src
d
Selects the modulation source used for both LFO speed and step speed
Amt
Sets the modulation amount of LFO speed
LFO Step Freq (Frequency) [Hz]
Sets the LFO step speed (speed that changes in steps)
e
Amt
Sets the modulation amount of LFO step speed
BPM/MIDI Sync
Switches between using the frequency of the LFO speed and using the
tempo and notes
BPM
Selects MIDI Clock and assigns tempo
f
Base Note
Selects the type of notes that specify the LFO speed
Times
Sets the number of notes that specify the LFO speed
Step Base Note
Selects the type of notes to specify the LFO step speed
g
Times
Sets the number of notes to specify the LFO step speed
Depth
h
Sets the depth of LFO modulation
Feedback
Sets the feedback amount
i
High Damp [%]
Sets the feedback damping amount in the high range
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
j
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175

Wet / Dry
Flanger
Feedback
High Damp
Flanger
Wet / Dry
LFO Phase
0.0...50.0msec
Step-Tri, Random
Fx:010
–180...+180
Fx:010
0.02...20.00Hz
Fx:010,
Off...Tempo
–20.00...+20.00Hz
0.05...50.00Hz
Fx:010,
–50.00...+50.00Hz
Fx:009,
MIDI, 40...240
Fx:009, 010
Fx:009
Fx:009
Fx:010,
Fx:010
–100...+100
Fx:020
Fx:020
–Wet...–1:99, Dry, 1:99...Wet
Fx:010, 020,
Off...Tempo
–100...+100
022: Envel.Flang

(Stereo Envelope Flanger)

This Flanger uses an envelope generator for modula‐
tion. You will obtain the same pattern of flanging each
time you play. You can also control the Flanger directly
using the modulation source.
Stereo In - Stereo Out
Left
Right
D
-mod
EG Attack/Decay
L Dly Bottom [msec] (L Delay Bottom)
Sets the lower limit of the delay time on the left channel
a
L Dly Top [msec] (L Delay Top)
Sets the upper limit of the delay time on the left channel
R Dly Bottom [msec] (R Delay Bottom)
Sets the lower limit of the delay time on the right channel
b
R Dly Top [msec] (R Delay Top)
Sets the upper limit of the delay time on the right channel
Sweep Mode
Determines whether the flanger is controlled by the envelope generator or by
the modulation source
c
Src
Selects the modulation source that triggers the EG (when EG is selected for
Sweep Mode), or modulation source that causes the flanger to sweep (when
D-mod is selected for Sweep Mode)
EG Attack
Sets the EG attack speed
d
EG Decay
Sets the EG decay speed
Feedback
e
Sets the feedback amount
High Damp [%]
f
Sets the feedback damping amount in the high range
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Off, On
Src
g
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
c: Sweep Mode, c: Src
x1...x16
This parameter switches the flanger control mode. With
"Sweep Mode" = EG, the flanger will sweep using the enve-
lope generator. This envelope generator is included in the
envelope flanger, and not related to the Pitch EG, Filter EG, or
x1...x32
Amp EG.
The "Src" parameter selects the source that starts the enve-
0...100
lope generator. If you select, for example, Gate, the envelope
generator will start when the note-on message is received.
When "Sweep Mode" = D-mod, the modulation source can
0...100%
control the flanger directly. Select the modulation source
using the "Src" parameter.
The effect is off when a value for the modulation source specified for
the "Src" parameter is smaller than 64, and the effect is on when the
value is 64 or higher. The Envelope Generator is triggered when the
value changes from 63 or smaller to 64 or higher.
d: EG Attack, d: EG Decay
Attack and Decay speed are the only adjustable parameters
on this EG.

Flanger
Feedback
High Damp
Flanger
D-mod
Sweep Mode
EG
–Wet...–1:99, Dry, 1:99...Wet
Fx:010, 020,
Wet / Dry
Wet / Dry
0.0...50.0msec
Fx:009
0.0...50.0msec
Fx:009
0.0...50.0msec
Fx:009
0.0...50.0msec
Fx:009
EG, D-mod
,
Off...Tempo

1...100

1...100

–100...+100
Fx:020
0...100%
Fx:020
Off...Tempo
–100...+100