Lfo2; Effects; Fx1 Editing; Fx2 Editing - Korg microARRANGER Owner's Manual

122 Program operating mode
Page 18 - LFO2
PAGE 18 - LFO2
Here you can make settings for the LFO2, which is the
second LFO that can be applied to the selected oscilla‐
tor. See "Page 17 ‐ LFO1" for more information on the
parameters value.
However in "Frequency modulation", the LFO cannot
be selected as a modulation source in "AMS1" or
"AMS2."
PAGE 19 - EFFECTS
Here you can select two effects for the whole Program,
switch them on/off, and specify chaining.
Note: For details on the effects, refer to the "Effects" chapter.
FX1/2
Use these parameters to select the effect type for effect
1/2. See the "Effects" chapter for more information.
Note: If 000: No Effect is selected, the output from the mas‐
ter effect will be muted.
Send
Send level for each effect.
Drum samples have their own send level settings (see
"Send FX1" and "Send FX2" on page 109). Use this
parameter to adjust the general offset of the Drum Pro‐
gram.
000...127 Effect level.
Chain 2>1
Use this parameter to send the output of effect 2 to the
input of effect 1.
000...127 Level of the signal exiting the effect 2
going back to the effect 1.
Send to Master
This parameters allows you to decide if the direct +
effected signal must go to the Master, or just the
effected signal.
Yes Only the effected signal will be sent to the
Audio Outputs. The direct (non‐effected)
signal will not be sent.
No Both the effected signal and direct signals
will be sent to the Audio Outputs.
PAGE 20 - FX1 EDITING
In this page you can edit the effected assigned to the
FX1 (A or C) effect processor (usually reverb). See the
"Effects" chapter for more information.
PAGE 21 - FX2 EDITING
In this page you can edit the effected assigned to the
FX2 (B or D) effect processor (usually modulating
effect). See the "Effects" chapter for more information.