Mixer: Volume; Mixer: Pan; Mixer: Fx Send; Page 1 ‐ Mixer: Volume - Korg microARRANGER Owner's Manual

edit page. After selecting a parameter, you can change
its value by pressing one of the two buttons in a pair, or
using the TEMPO/VALUE controls.
PAGE 1 - MIXER: VOLUME
This page lets you set the volume for each of the Real‐
time (Keyboard) or Style tracks.
Use the TRACK SELECT button to switch from the Real‐
time (Keyboard) tracks to the Style tracks, and vice versa.
Volume
Track's volume.
0...127 MIDI value of the track's volume.
PAGE 2 - MIXER: PAN
This page lets you set the pan (position in the stereo
front) for each track.
Use the TRACK SELECT button to switch from the Real‐
time (Keyboard) tracks to the Style tracks, and vice‐versa.
Pan
L‐64 Hard Left.
C+00 Center.
Style Play operating mode
R+63 Hard Right.
Off The direct (uneffected) signal does not go
to the outputs; only the FX signal is heard
for this track.
PAGE 3 - MIXER: FX SEND
This page lets you set the level of the track's direct
(uneffected) signal going to the Internal FX processors.
The effect processors included in microARRANGER
are connected in parallel, so you can decide which per‐
centage of the direct signal should be effected:
Track
FX Processor
There are four Internal FX processors in Style Play
mode. You can assign them any kind of available
effects, but we found it convenient to arrange them in
the following way, for all the Styles included with the
microARRANGER:
A Reverb processor for the Style tracks.
B Modulating FX processor for the Style tracks.
C Reverb processor for the Realtime (Keyboard)
tracks.
D Modulating FX processor for the Realtime (Key‐
board) tracks.
Use the TRACK SELECT button to switch from the Real‐
time (Keyboard) tracks to the Style tracks, and vice‐versa.
To select a parameter and edit its value:
1. Use the VOLUME/VALUE (A–H) buttons to select
a track.
2. Use the F‐1–F‐4 buttons to select one of the effect
processors.
3. Use the TEMPO/VALUE controls to change the value.
Send level
000 No effect. Only the direct (uneffected) sig‐
nal goes to the outputs.
127 100% effect. The direct (uneffected) and
effected signals go to the outputs with the
same level.
43
Page 1 - Mixer: Volume
Output