HP TR3271 Programming Manual page 93

ZSPI-TKN-RETCODE specifies the return code for the command.
token is described in "SPI Standard Definitions" in Section 5
and the Distributed Systems Management (DSM) Programming Manual .
For details on the data-communications error numbers and their
associated error lists, see "Common Error Numbers and Error
Lists" in the Communications Management Programming Manual .
details on the TR3271 error number and their associated error
lists, see Appendix A in this manual.
The possible nonzero values of RETCODE in response to the ALTER
command are as follows:
ZCOM-ERR-VAL-REQ (-31)
ZCOM-ERR-TKN-VAL-INV (-30)
ZCOM-ERR-TKN-LEN-INV (-28)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJNAME-INV (-19)
ZCOM-ERR-OBJ-NOT-FOUND (-17)
ZCOM-ERR-FNAME-INV (-9)
ZCOM-ERR-CMD-TIMED-OUT (-7)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
Your management application has tried to alter an object that
is not supported by the TR3271 subsystem.
objects are PROC, LINE and SU.
must specify the value ZCOM-OBJ-LINE or ZCOM-OBJ-SU.
ZCOM-ERR-NO-MEM-SPACE (-14)
The subsystem cannot alter the subdevice at this time because
the necessary memory for the line or subdevice control block
cannot be allocated.
ZCOM-ERR-CMD-MISMATCH (-4)
Your management application tried to alter a process by using
the value ZCOM-OBJ-PROC.
value ZCOM-OBJ-LINE or ZCOM-OBJ-SU.
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to alter a line or subdevice
while the line was in the DIAG summary state.
state prevents processing of the ALTER command.
COMMANDS AND RESPONSES
For the ALTER command, you
The command is valid only for the
ALTER Command
This
For
The supported
This summary
6-29