Table of Contents
Advertisement
ZREAD-CMD
ZRETRY
ZSYNCS
ZTEST-INTVL
ZTHRES
ZTIMEOUT
An enumerated value that specifies whether the
TR3271 subsystem accepts the Read Buffer and
Read Modified command from the host.
ZTR3-VAL-READ-NONE causes the subsystem to reject
the Read Buffer and Read Modified commands.
value ZTR3-VAL-READ-ALL causes the subsystem to
accept both the Read Buffer and Read Modified
commands.
ZTR3-VAL-READ-RDMOD causes the subsys-
tem to accept the Read Modified command, but
reject the Read Buffer command.
The Read Buffer command is supported only for
CRT subdevices.
specifies the ZTR3-VAL-READ-ALL for PTP
subdevices, Read Buffer commands are rejected.
This restriction is imposed by the protocol used
by PTP subdevices.
field is ZTR3-VAL-READ-NONE.
An integer that specifies the number of times the
TR3271 retransmits data as a result of data link
errors before returning an error.
be in the 1 through 14 range.
An integer that specifies the number of SYN
characters that precede each frame.
must be in the 1 through 14 range.
is 3.
A timestamp that specifies the interval, in .01
seconds, at which the status probe is issued to
the CLIP.
The value must be in the range 0
through 5:27:67.
probe will be issued.
seconds).
An integer that specifies the statistics thresh-
old values.
This value defines the number of
frames to be transmitted and received before line
quality is checked.
0 through 32767 range.
threshold is ignored.
A timestamp that specifies the line I/O timeout
value, in .01 seconds.
long the I/O process waits before retrying when
a data link error occurs.
the range 00:00.6 through 00:10.
00:02.7.
COMMANDS AND RESPONSES
If your management application
The default value for this
The default is 3.
If the value is 0, no status
The default is :10 (10
The value must be in the
If the value is 0, the
The default is 0.
This value defines how
The value must be in
INFO Command
The value
The
The value must
The value
The default
The default is
6-57
Advertisement
Table of Contents
