Switch Command - HP TR3271 Programming Manual

COMMANDS AND RESPONSES

SWITCH Command

SWITCH Command
The SWITCH command switches a process to another CPU or a line to
another path. However, if the TR3271 I/O process is running in
a single-port CIU-based implementation of 6100 CSS, both the CPU
and path are switched when your management application issues the
SWITCH command.
You cannot switch a subdevice.
When the subsystem completes processing this command, the speci-
fied object remains in the same summary state it was in before
the command was issued.
The only summary state requirement when issuing this command is
that the LINE object cannot be in the DIAG summary state.
When your management application issues the SWITCH command for
the PROC or LINE object, the resource being switched to must
exist and cannot be the same one currently in use by the named
object. If the resource does not exist, the command is rejected.
If the resource is currently in use, the command completes with a
warning.
In addition, if the ZCOM-TKN-SWITCH-CPU is specified, the CPU
being switched to must be the CPU for the backup process defined
during system generation.
Command
ZCOM-CMD-SWITCH
Object Type
ZCOM-OBJ-PROC
or
ZCOM-OBJ-LINE
Tokens in Command Buffer
ZCOM-TKN-OBJNAME
ZCOM-TKN-SWITCH-CPU
ZCOM-TKN-SWITCH-PATH
ZCOM-MAP-REQID
6-114
token-type ZSPI-TYP-STRING.
token-type ZSPI-TYP-INT.
token-type ZSPI-TYP-ENUM.
!MAP is optional, but if present,
!fields are required.
!{}
!{A}
!OBJ-PROC
!{A}
!OBJ-LINE
>