Table of Contents
Advertisement
ZCOM-TKN-OBJTYPE specifies the type of object that was switched.
This token can have the value ZCOM-OBJ-PROC or ZCOM-OBJ-LINE.
This token is described in "Data-Communications Standard
Definitions" in Section 5, "Common Definitions," and the
Communications Management Programming Manual .
ZSPI-TKN-ERRLIST indicates the beginning of an error list.
This token is described in the Distributed Systems Management
Programming Manual .
ZSPI-TKN-RETCODE specifies the return code for the command.
token is described in "SPI Standard Definitions" in Section 5
and the Distributed Systems Management (DSM) Programming Manual .
For details on the data-communications error numbers and their
associated error lists, see "Common Error Numbers and Error
Lists" in the Communications Management Programming Manual .
The possible nonzero values of RETCODE or within the error list
in response to the SWITCH command are as follows:
ZCOM-ERR-EMPT-RSP (-33)
ZCOM-ERR-TKN-VAL-INV (-30)
ZCOM-ERR-TKN-REQ (-29)
ZCOM-ERR-TKN-DUP (-27)
ZCOM-ERR-TKN-CODE-INV (-26)
ZCOM-ERR-SSID-INV (-24)
ZCOM-ERR-SECUR-VIOL (-22)
ZCOM-ERR-OBJ-NOT-SUPP (-18)
ZCOM-ERR-FNAME-INV (-9)
ZCOM-ERR-CMD-TIMED-OUT (-7)
ZCOM-ERR-RES-NOT-CONFIG (-21)
Your management application specified a CPU or path that was
not configured at system generation time and is therefore
unknown to the target subsystem.
ZCOM-ERR-CMD-MISMATCH (-4)
Your management application tried to switch a subdevice by
using the value ZCOM-OBJ-SU.
the value ZCOM-OBJ-PROC or ZCOM-OBJ-LINE.
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to switch a process or line
while the line was in the DIAGNOSING summary state.
DIAGNOSING summary state prevents processing of the SWITCH
command for the process or line object.
COMMANDS AND RESPONSES
The command is valid only for
SWITCH Command
This
The
6-117
Advertisement
Table of Contents
