Leg Kit & Ash Removal System (Ars) Installation - Quadra-Fire 31M-ACC-GT Owner's Manual

R
B. Leg Kit and Ash Removal Installation
(ARS) for Step Top Uni-Body
NOTE: The Ash Removal System, must be
installed fi rst before installing the legs.
Begin installing the ARS System.
1. Follow steps 1 through 6 on page 21.
Installing Leg Kit
1. Remove leg mounting brackets packaged inside fi rebox.
2. Attach the 2 bottom screws of the mounting brackets to the
bottom of the stove with 1/4"-20 Phillips screws. These screws
are located in the component pack. Leave the bottom 2 screws
loose so you can slide the ash pan assembly bottom slots over
the screw heads. This allows the weight of the ash pan to
rest on the screws while you are attaching the top 2 screws.
Once the ash pan is attached, tighten all screws.
3. Loosely assemble bolts into the corner of the mounting brack-
ets for leg attachment.
4. Slide legs onto mounting brackets and tighten. Make sure the
legs are up against the bracket. There are leveling bolts in 2
legs. These leveling legs should be in opposite corners.
5. Carefully stand stove up and place in desired location. Do NOT
tilt up on the cast iron legs, it could damage the legs.
6. Use leveling bolts on legs to stabilize and level stove.
Finishing the ARS Installation
1. Follow steps 1 through 3 on page 22. See also Figure 22.2.
Figure 23.1
March 2, 2007
Leg Mounting Brackets are
packaged inside firebox.
Leveling Legs at
opposite corners
Lay stove flat on its
back on protective
padding or pallet
Figure 23.2
Do NOT tilt the unit on the cast iron legs.
• Tilting could lead to property damage.
• Lift the unit upright and place it into position on the
fl oor protector.
7033-277C
3100 Wood Stove Series (ACC)
Insert 2 bottom
screws loosely
Leg Brackets
CAUTION
Ash Drawer
Page 23