Table of Contents
Advertisement
Adapters
Figure 20.1
ARS Access
Cover
Reinstall 2 front
bricks back into
Figure 20.2
Figure 20.3
20
Ash Removel
Drawer
ARS
Channel
firebox
Cover
Plate
C. Access Cover Handle
Insert Access Cover Handle handle into slot of ARS Cover
to remove ARS Cover for cleaning ash out of firebox (Figure
20.4).
Figure 20.4
D. Leg Kit & ARS Installation
NOTE: The Ash Removal System, must be installed first
before installing the legs.
Begin installing the ARS System.
1. Remove leg mount brackets packaged inside of firebox
and set aside.
2. Remove the 2 bricks in the front most part of the firebox
(Figure 18.2).
3. Lay appliance on its back on a protective pad or pallet
(Figure 18.3).
4. Remove heat shield by loosening the four bolts using 3/8
open end wrench (Figure 18.3).
5. Remove (8) nuts that hold the cover plate on using a
7/16 socket wrench; discard cover plate (Figure 18.3).
CHECK GASKET!
• Verify that the gasket is present and that the glossy
side is away from firebox bottom.
• It is important that the gasket is put in correctly for
sealing capabilities.
7037-806A
WARNING
05/21
Advertisement
Table of Contents
